Trusted South Pasadena Roof Repair & Replacement

Replacing your roof isn't just about shingles. We install ice and water shield in the valleys and along eaves, synthetic underlayment across the whole deck, new drip edge on rake and eave, starter strip, and ridge vent. That's how a roof lasts 30 years in California.

Step flashing at chimney walls is the number one leak source we see in South Pasadena. Improper step flashing causes roof leaks. It's that simple. We install new step flashing with a chimney cricket for proper water diversion, sealed with Geocel tripolymer sealant. Fix it once, fix it right.

HAAG Certified Inspector on every storm claim we handle in South Pasadena. HAAG certification is the insurance industry standard for forensic roof inspection. Adjusters trust our reports. We document hail hits per square, wind creasing, and granule displacement. FM 4473 hail resistance ratings determine whether your roof qualifies for full replacement or spot repair.

New construction roof installation following IRC Section R905 and local South Pasadena building code amendments. We calculate ventilation per IRC R806 (1:150 ratio reduced to 1:300 when 50% is within 3ft of ridge. Synthetic underlayment per ASTM D226, ice barrier per ASTM D1970 at eaves in freeze-thaw climate zones. Manufacturer-certified installation locks in the full system warranty.

Metal roofing costs more upfront at $12-$22 per sq ft installed in South Pasadena compared to $4-$8 for shingles. But it lasts 2-3x longer and your energy bills drop 15-25%. Math works out over time.

We install asphalt shingles from every major manufacturer. GAF, Owens Corning, CertainTeed, Atlas, Tamko, Malarkey, IKO. Each has different warranty tiers and price points. We walk you through the comparison without pushing one brand.

TPO single-ply membrane in 60-mil or 80-mil thickness, hot-air welded seams, fully adhered or mechanically attached over polyiso insulation board. We install per NRCA and manufacturer specifications. Ponding water is the number one cause of flat roof failure. We use tapered ISO insulation to create minimum 1/4" per foot slope to drains. FM 4473 rated systems available for hail-prone South Pasadena areas.

We install Carlisle SynTec TPO and EPDM membrane systems with full Carlisle manufacturer warranties. Our South Pasadena commercial roofing crews are factory-trained and authorized. TPO seams are hot-air welded at 900+ degrees. The weld is stronger than the membrane itself. Ponding water? We install tapered ISO insulation to create positive drainage per NRCA guidelines.

Gutters aren't glamorous, but they're protecting your foundation, your fascia, and your landscaping. We install seamless aluminum gutters custom-formed on-site from a roll of coil stock. No seams means no leaks.

We climb up, walk the entire roof, and document what we find with photos and measurements. Takes about 30 minutes. You see exactly what we see. No mysteries, no scare tactics.

Fallen tree limb damage requires structural assessment before repair. We check rafter integrity, decking condition, and whether the ceiling joists below were impacted. If structural members are cracked or displaced, you need a framing carpenter before we re-roof. We coordinate with trusted South Pasadena contractors for structural work. Insurance carriers require separate line items for structural vs. roofing repairs. We document both.

VELUX FS fixed skylights and VS vented skylights installed with EDL flashing kits for profile roofing. The flashing integrates with your shingle courses per IRC R903.2 weather protection requirements. We cut the opening, frame the curb with doubled 2x lumber, install the skylight with factory sealant, and weave the flashing into the existing shingle field. Leak-proof when done right. And we do it right in South Pasadena.